Worldlawn WYZ 48, Руководство оператора

Страница: 36 / 44

32
5.2.8 Adjust Throttle Lever Tension.
a) Stop engine wait for all moving parts to stop, and remove key.
b) Tension in throttle lever can be adjusted by adjusting the tightness of the lever pivot bolt, which is
located under the console.
5.2.9 Electric Clutch Adjustment:
No adjustment necessary.
5.2.10 Reverse Adjustment:
No adjustment necessary.
5.2.11 Motion control linkage adjustment.
POTENTIAL HAZARD
◆
Engine must be running and drive wheels must be turning so motion control
adjustment can be performed.
WHAT CAN HAPPEN
◆
Contact with moving parts or hot surface may cause personal injury.
HOW TO AVOID THE HAZARD
◆
Keep fingers, hands, and clothing clear of rotating components and surfaces.
POTENTIAL HAZARD
◆
Raise the mower deck for service or maintenance relying solely on mechanical or
hydraulic jacks could be dangerous.
WHAT CAN HAPPEN
◆
The mechanical or hydraulic jacks may not be enough support or may malfunction
allowing the unit to fall, which could cause injury.
HOW TO AVOID THE HAZARD
◆
Do not rely solely on mechanical or hydraulic jacks for support. Use adequate jack
stands or equivalent support.
a) This adjustment must be made with the drive wheels turning. First raise the frame and block up so
that drive wheels can rotate freely.
b) Remove the electrical connection from the seat safety switch, located directly to the left of the seat
switch assembly beside the hydraulic oil reservoir.
Temporarily
install a jumper wire across the
terminal in connector of the wiring harness.
c) Run the unit at least 5 minutes with the drive levers at full forward speed to bring hydraulic system
oil up to operating temperature.
d) Unhook seat latch and tilt seat forward.
e) Start engine.
Brake must be engaged and motion control levers out to start engine .operator
does not have to be in the seat because of the jumper wire being used
. Run engine at full
throttle and release brake.