HANGZHOU BLUE WHALE MUSIC TECHNOLOGY CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:[email protected] TEL:86 571 88730848
- 12 -
Reference RGB No. for some colors:
COLOR
R. G. B
WHITE
127 127 127
BLACK
0 0 0
RED
127 0 0
GREEN
0 127 0
BLUE
0 0 127
CYAN
0 127 127
MAGENTA
127 0 127
YELLOW
127 127 0
ORANGE
127 82 0
5.8 Other controls
5.8.1 Store all parameters
Press the MENU button repeatedly until the OLED dispays “Store all parameters” to start the function of storing parameters. It stores 3
groups setup value. When this function is valid, the OLED displays the “Store all parameter” and the current strorage group number. It
can be adjusted by value dial and confirmed by Enter button. The initial value is 1, adjusting scale is 1
～
3. The operation steps is shown as
below and the OLED displays the following:
(1) Press the MENU button repeatedly until the OLED dispays “Store all parameter”.
(2) Rotate the value dial to adjust the memory area and the OLED will display the current memory area.
(3) Press the “Enter” button to confirm and the OLED will display “Done”. Holding the “Enter” button for 2 seconds to exit the edit mode and
return to parameter display mode.Then if you rotate the knobs, move the sliders or trigger the pads the OLED will display the current
parameters of these controllers.
5.8.2 Recall all parameters
Press the MENU button repeatedly until the OLED dispays “Recall all parameter” to start the function of recalling all parameters. When this
function is valid, the OLED displays the “Recall all parameter” and the current strorage group number. It can be adjusted by value dial and
confirmed by Enter button. The initial value is 1, adjusting scale is 1
～
3. The operation steps is shown as below and the OLED displays the
following:
(1) Press the MENU button repeatedly until the OLED dispays “Recall all parameter”.
(2) Rotate the value dial to select the memory area and the OLED will display the current memory area.
(3) Press the “Enter” button to confirm and the OLED will display “Done”. Holding the “Enter” button for 2 seconds to exit the edit mode and
return to parameter display mode.Then if you rotate the knobs, move the sliders or trigger the pads the OLED will display the current
parameters of these controllers.
5.8.3 RESET
Press the MENU button repeatedly until the OLED dispays “Reset all” to reset the system restoring to factory setting, sending system initial
setting info at the same time. When this function is valid, the OLED displays the “Reset all”. It can be confirmed by Enter button. The OLED
displays the following:
