Battery Cover
4 AA Batteries
(Not included.)
First remove the screw on
the battery cover and then
remove the battery cover
itself. Next install 4 AA
batteries with the correct
polarity. Finally replace the
battery cover and screw it
in place.
CAUTION:
1. Make sure the polarity of the
batteries are correctly installed.
2. Do not mix old and new
batteries.
3. Do not mix different types
of batteries.
INSTALLING THE TRANSMITTER BATTERIES
INSTALLING THE DRONE BATTERY
CAUTION WHILE CHARGING:
Do not charge with batteries still installed. Do not charge battery unsupervised. Do not immediately charge after
use. Do not overcharge battery.
Ideal charge time is 50-60 minutes.
Overcharging can cause a catastrophic
failure. Always charge on dry and ventilated areas away from any heat source or flammable materials. Always
use the original USB charging cable provided. Promptly change and replace old or defective batteries.
Battery Type
Battery Specification
Usage Duration
Charge Time
BATTERY PACK SPECIFICATIONS
LiPo Battery
3.7V 380mAh
Flight Duration 6 - 8 minutes
Charging Time 50 -60 minutes
5
1
3
Test the power by pressing in on the
drones power button. The drones
lights will turn on if the battery was
installed properly.
Make sure the battery is turned off
by pressing the button on top of the
drone so that it sticks out. Open the
battery compartment.
CHARGING THE DRONE BATTERY
Remove the battery from the battery
compartment underneath the drone.
Disconnect the battery cable from
the drones power cable located
inside the compartment.
Connect the battery pack to the
included USB charger then plug the
USB to any powered USB port.
Make sure the battery is turned off
by pressing the button on top of the
drone so that it sticks out. Open the
battery compartment.
Connect the battery cable to the
drones power cable located inside
the compartment. Then place the
battery inside and close the cover.
2
3
1
2
