6
PREFLIGHT PREP / SYNCING THE DRONE TO THE REMOTE
1. Make sure the battery pack is connected properly and the drone shell is secure.
2. Flip the power switch on the side of the drone and place the drone on a flat surface with no
obstructions in its flight path. The drone’s LED lights will begin to flash.
3. Turn on the transmitter by pressing the button at the center. The power indicator on the
transmitter will start flashing.
4. Push the left joystick on the transmitter all the way down, then all the way up and then all the way
back down again. The remote will beep twice and the LED lights on the drone and the power
indicator light on the remote will stop flashing. This means the drone is paired. (If this does not
occur, turn off the remote and drone and try again.
5. Once paired, the drone is ready to fly. All you need to do is gently push up on the transmitter’s
throttle stick and the rotors will start to spin. Continue slowly pushing up on the throttle stick to take
off. It is STRONGLY recommended that you use the drone outdoors during initial flights.
CHANGING THE DRONES SHELL
The drone has a removable shell that you can replace if damaged. You can also change the color of
your drone with a new shell (Sold Separately). Follow the directions to change the drone shell.
Remove the battery first. Focus on one
side of the drone at a time. Push in on
the sides of the drone shell so that the
tabs slide out of the drone tabs.
Once the shell tabs are all released
take the shell off by pulling up and
back towards the rear of the drone.
This will allow you to slide the tab out
the front of the drone.
Insert the new shell’s front tab into the
front of the drone at an angle.
Push the shell back into place and
make sure the side tabs are clipped
back in and secure.
