11
RACING RINGS ASSEMBLY
Two of the included racing rings have LED
lights that are each powered by a battery box.
To start, remove the single screw on each of
the battery covers and then slide them off
towards the plug and switch. Next install 2 AA
batteries with the correct polarity into each
battery box. Finally replace the battery covers
and screw them in place. The boxes are now
ready to be connected to the red and blue
racing rings.
The three racing rings are easily assembled using the 4 parts shown below. The red and blue racing rings
have a small black power plug sticking out from the side, do not pull on the plug or damage to the LED lights
may occur. The checkered flag racing ring is identical to the red and blue ring but it does not have any
electronics. Follow the steps below to assemble each of the racing rings.
Battery Cover
2 AA Batteries
(Not included.)
1
2
Lay the base piece on a flat surface
and insert the racing ring into the two
slots.
Insert the two side pieces by lining
them up with the slots on the racing
ring as shown.
