World Cat 230CC, Руководство пользователя

Страница: 20 / 62

20 20 World Cat Glacier Bay Edition 2740 Owner’s Manual
19
5.6.1 Steering System - Bleeding Instructions
Reference the bleeding instructions provided by the SeaStar Solutions
®
owner’s manual, which is included
in your Owner’s Portfolio. Use them in conjunction with the instructions and diagram below to bleed the
steering system. This should be done annually or when air is detected in the system.
Step 1
• Using a filler tube, fill the helm with oil.
• When completed, you should be able to see oil in the filler tube.
• Do not proceed with step two until helm is full of oil.
Step 2
• Open the bleed fitting labeled #1 and pull the cylinder
shaft all the way out on the fitting #1 side.
• Holding the shaft to prevent it from moving back into
the cylinder, have someone turn the wheel clockwise
until a steady stream of oil flows through the fitting.
• Close bleed fitting #1.
Step 3
• Open the bleed fitting labeled #2 and pull the cylinder
shaft all the way out on the fitting #2 side.
• Holding the shaft to prevent it from moving back into the
cylinder, have someone turn the wheel counter-clockwise
until a steady stream of oil flows through the fitting.
• Close bleed fitting #2.
Step 4
• When you complete the bleeding process, turn the
wheel hard over in each direction at least twice.
• Then manually adjust the cylinders by pulling the shaft
all the way out on the same side of each cylinder and
closing the steering system valve.
NOTICE
If possible, have your dealer or trained marine technician perform routine maintenance or repairs on
your steering system. Replace faulty parts immediately.