AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1800 909 909
24v Lithium-ion Cordless Drill with Hammer Action
MODEL: №. 51887 • 06/2016 • 51887
8
b. Only use chargers recommended by the manufacturer to recharge the
battery. There is a risk of fire if it is used with other batteries.
c. Never use to recharge third-party batteries. The charger is only designed
to charge the supplied batteries (Li-Ion) using the voltages specified in the
Technical Data. Otherwise there is a risk of fire or explosion.
d. Keep the charger clean. Contamination will increase the risk of an electrical
shock.
e. Check the charger, cable and plug each time you use the unit. Do not use
the charger if you find any damage. Never open the charger up yourself, have
it repaired by a qualified specialist only and with original replacement parts.
A damaged charger, cable or plug will increase the risk of an electrical shock.
f. Never operate the charger on a surface that will burn easily (for example,
paper, textiles etc) or in a flammable environment. There is a risk of fire
occurring as a result of the heat generated during the charging process.
g. Fluid can escape from the battery when used incorrectly. Avoid all contact
with this. In the event of accidental contact, rinse with water. If liquid should
get into the eyes, get medical assistance. Battery fluid may result in skin
irritations and burns.
h. Do not open the battery. There is a risk of short-circuiting.
i. Protect the battery from heat, for example, from constant sun and fire.
There is a risk of explosion.
j. Never short circuit the battery. There is a risk of explosion.
k. In the event of damage and incorrect use, vapours may come out of
the battery. Ensure your work space is well ventilated with fresh air and, if
you have any symptoms, consult a doctor. These vapours may irritate the
respiratory system.
Safety rules for cordless drill/driver
a) Hold tool by insulated gripping surfaces when performing an operation
where the drill/driver bits may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed metal parts of the tool “live” and
shock the operator.
b) Always wear safety goggles or eye protection when using this tool.
Use a dust mask or respirator for applications which generate dust.
c) Secure the material being drill/drivered. Never hold it in your hand or
across legs. Unstable support can cause the drill/driver bit to bind causing loss
of control and injury.
