E41
E42
E43
E44
E45
E46
E47
E48
E49
E50
E51
E52
E53
E54
E55
E56
E57
E58
E59
E60
E61
E62
E63
E64
E65
E66
E67
E68
E69
E70
E71
E72
E73
E74
E75
E76
E77
E78
E79
E80
E81
E82
-
-
*Not applicable if the lower position is limited.
Step 1: Put the desk at the lowest position.
Step 2: After the desk is in its lowest position,
release the control and then hold it down again
until the desk makes a small movement down
and up.
Initialization (Reset):
Error codes
Initialization
Initialization
Initialization
Initialization
Initialization
Initialization
Channel 1 overload UIT
Overload in outward motion
Better weight distribution between columns/remove excess weight
Channel 2 overload UIT
Better weight distribution between columns/remove excess weight
Channel 3 overload UIT
Better weight distribution between columns/remove excess weight
Channel 4 overload UIT
Better weight distribution between columns/remove excess weight
Channel 5 overload UIT
Better weight distribution between columns/remove excess weight
Channel 6 overload UIT
Better weight distribution between columns/remove excess weight
Channel 1 overload IN
Overload in downward motion
Obstacle removal / in misalignment initialization
Channel 2 overload IN
Obstacle removal / in misalignment initialization
Channel 3 overload IN
Obstacle removal / in misalignment initialization
Channel 4 overload IN
Obstacle removal / in misalignment initialization
Channel 5 overload IN
Obstacle removal / in misalignment initialization
Channel 6 overload IN
Obstacle removal / in misalignment initialization
Channel 1 Anti-Collision Protection
the limit of anti-collision protection has been exceeded
Obstacle removal / in misalignment initialization
Channel 2 Anti-Collision Protection
Obstacle removal / in misalignment initialization
Channel 3 Anti-Collision Protection
Obstacle removal / in misalignment initialization
Channel 4 Anti-Collision Protection
Obstacle removal / in misalignment initialization
Channel 5 Anti-Collision Protection
Obstacle removal / in misalignment initialization
Channel 6 Anti-Collision Protection
Obstacle removal / in misalignment initialization
Channel 1 SLS activated
SLS is activated
Obstacle removal / in misalignment initialization
Channel 2 SLS activated
Obstacle removal / in misalignment initialization
Channel 3 SLS activated
Obstacle removal / in misalignment initialization
Channel 4 SLS activated
Obstacle removal / in misalignment initialization
Channel 5 SLS activated
Obstacle removal / in misalignment initialization
Channel 6 SLS activated
Obstacle removal / in misalignment initialization
Channel 1B type
Port B OR channel type has been changed
Channel 2B type
Channel 3B type
Channel 4B type
Channel 5B type
Channel 6B type
Channel 1A shorted
Short circuit detected on output :
Remove power cord/ check cables/ initialization
Channel 1B shorted
Remove power cord/ check cables/ initialization
Channel 2A shorted
Remove power cord/ check cables/ initialization
Channel 2B shorted
Remove power cord/ check cables/ initialization
Channel 3A shorted
Remove power cord/ check cables/ initialization
Channel 3B shorted
Remove power cord/ check cables/ initialization
Channel 4A shorted
Remove power cord/ check cables/ initialization
Channel 4B shorted
Remove power cord/ check cables/ initialization
Channel 5A shorted
Remove power cord/ check cables/ initialization
Channel 5B shorted
Remove power cord/ check cables/ initialization
Channel 6A shorted
Remove power cord/ check cables/ initialization
Channel 6B shorted
Remove power cord/ check cables/ initialization
