Workshop WS1600SS0, Руководство пользователя

Страница: 8 / 60

8
DRUM/CADDY ASSEMBLY
(continued)
7. Insert the caster stem into the socket of
the caster foot as shown. (Front casters
only).
8. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the caster
will swivel easily when positioning is
correct.
WET/DRY VAC ASSEMBLY
9. Rotate drum/caddy assembly upright,
using a long phillips screwdriver, install
(8) #10 x 3/4” screws into matching
holes on both right and left side of
caddy. Tighten screws until just snug.
Do not over tighten as this may tend to
deform the caddies.
LE
FT
Socket
Caster Stem
Caster Ball
#10 x 3/4"
Screw (8)
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Handles
Latch
Drum
Latch
Drum
Drum
Latch
Insert Hose
Insert the push button end of the Dual-
Flex™ Locking hose into the inlet of the
Vac. The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
Release
Button Press
and
Pull
SP6851-1 Workshop :SP6439-3_ES.qxd 9/20/13 11:58 AM Page 8