mAINTeNANce
filter
NoTe:
This Filter is made of high quality
paper designed to stop very small
particles of dust. The Filter can be used
for dry pick up or limited wet pick up.
Handle the Filter carefully when removing
or installing. Creases in the Filter pleats
may occur from installation but creases
will not affect the performance of the
Filter.
8
To Remove Power head:
1.
Grasp the drum latches on both the
right and left side of the power head.
Slowly pull the drum latches away from
the drum. Lift the power head off the
drum. Place the lid assembly of the
Vac upside down.
WARNING: for your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac
with any parts damaged or missing.
Power
Head
Drum
Pull Out
And
Lift Up
Drum Latch
!
Removal and Installation
of the Qwik lock™ filter
filter Removal:
1.
Hold the Filter tabs of the Qwik Lock™
Filter in each hand.
2.
With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated Filter plate, lift up on the
Filter tabs while pushing down on the
stud.
3.
This action will cause the Filter to
release from the Filter cage. Slide Filter
off cage.
filter Installation:
1.
Carefully slide the Qwik Lock™ Filter
over the Filter cage and press down on
the outside edge of the Filter until the
rubber gasket on the bottom of the
Filter seats securely around the base
of the Filter cage and against the lid.
2.
Align the small center hole in the top of
the Filter over the Qwik Lock™ stud on
the Filter cage. Press firmly on top of
the Filter near the stud to allow the
Filter to snap over the ball on the end
of the stud. The Filter is now attached.
NoTe:
Failure to properly seat the
bottom gasket could result in debris
bypassing the Filter.
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
!
Filter
Cage
Filter
Tabs (2)
Integrated Filter
Plate with Center
Hole
PUSH
DOWN
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik Lock™
Stud
SP6930 Workshop.qxp_SP6439-3_ES.qxd 12/2/14 10:09 AM Page 8
