7
20
SAFETY INSTRUCTIONS
(continued)
When maneuvering close to buildings or passing through narrow areas, be sure to allow sufficient clearance
for the power unit, loader, and load. Drive slowly. Allow for additional length of loader and load on power unit
while turning.
Do not use the fork tines for prying or any purpose other than lifting.
Use extreme care when working on inclines and hillsides. Do not operate close to ditches, creeks or holes.
Slow down when operating over rough ground.
Keep load centered on attachment and loader. Unbalanced loads increase possibility of tipping or roll-over.
Secure the load properly. Unsecured loads can fall unexpectedly.
Never lift a load with one fork.
Be sure that people, livestock, or pets are not standing near the machine while operating. Never allow anyone
to walk or work under a raised loader.
Do not lift or carry anyone on loader or in bucket or on attachment. Do not use loader for a work platform.
ALWAYS lower loader to the ground or block securely before performing any maintenance work.
Always keep power unit on solid footing when operating loader.
Observe Safety Recommendations in loader instruction manual.
Inspect the entire machine periodically as indicated in the Maintenance Section of this manual. Look for loose
fasteners, worn or broken parts, pinched hydraulic hoses, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining this machine in good working order.
OPERATIONAL SAFETY (continued)
Be certain the power unit is in neutral or park position before starting engine.
Always shut off power unit and shift to “Park” or set brakes when leaving unit. Always lower bucket or
attachment to ground, relieve all hydraulic pressure. Remove key when leaving equipment unattended. Park in
level area.
MODELS MPF-2000 & MPF-2000B/G
PARTS LIST
