12 of 12
Workrite Ergonomics | (800) 959–9675 www.workriteergo.com
#1500353 Rev B
12
Put Work center Upright and Connect Power Cord to the Power Supply
12.1 Turn the work center over into an upright position.
Note: Always use at least two people to flip and move Work centers. Caution! Heavy!
11.2 Plug the Power Cord (T) into the power outlet.
13
Adjust Feet Glides
If necessary, adjust Foot Glides (M) on the feet to level the worksurface. Unscrew to increase height, screw in to
decrease height.
For
Center Foot, use "Glide Adjuster" as needed (comes in ¼" to ½" spacers).
✓
Cleaning instructions
To clean the Sierra legs, apply cleaner to a soft cloth.
Suggested cleaners: Windex or Formula 409.
Do not use solvents and do not saturate or spray cleaners directly to work center base.
You must complete this
initialization step or your
work center will NOT
function properly.
Hold down the down
arrow until work center
moves slightly upwards!
✓
Replacement Parts
Visit
http://workriteergo.com/documentation/other/workrite_ergonomics_pricing_specification_guide.pdf
for
replacement parts.
14
Initialize Legs
After all legs and the switch are connected, and the power cord has been plugged in, hold the
down arrow on
the switch until the legs make a short motion down and then back up. This initializes and synchronizes the work
center legs.
T
12.1
12.2
