4 of 9 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Position leg assembly
2.875" from the sides and 6.5"
from the back of the worksurface, making sure the legs
are parallel with the back edge of the worksurface.
Using the ⅛" drill bit, drill ¾" deep pilot holes in the four
corner locations.
ATTACH LEG ASSEMBLIES TO TOP
2.1
2.2
Note: We recommend you mark your drill bit at ¾" to
prevent drilling too deep.
Caution: Do not drill through the worksurface!
Install four (4) #12 × ¾" Phillips pan head screws (L) into the
4 corner locations and tighten securely.
Warning: Do not over-tighten and strip the screws into the top.
Using the ⅛" drill bit, drill ¾" deep pilot holes in the remaining
locations in brackets on the legs.
Install #12 × ¾" Phillips pan head screws (L) into all the pilot
holes and tighten securely.
2.3
2.4
2.5
2
Front
2.2
2.4
2.5
2.3
2.1
2.875"
6.5"
L
L
L
L
L
#12 × ¾" Phillips Pan Head
Screws
