6 of 12
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Front of desk
1.5"– 2"
1.5"– 2"
7.2"
7.2"
Expand Framesets to Correct Length
With Legs & Feet secure but the frameset
Joining Bracket still loose, extend the frameset
out towards the edge of the worksurface.
If you have a Workrite pre-drilled
Worksurface:
Align frameset holes with pre-drilled holes in
the undersides of the worksurface.
Adjust Joining Brackets so center bracket
hole aligns with the center hole location.
Proceed to
Step 6.
If you have a non- Workrite top:
Align frameset parallel with the back of the
worksurface.
Position frameset 7.2" from rear of Worksurface
and extend frameset until the Side Bars (D) are
about 1.5"–2" from the ends of the top.
Adjust Joining Brackets so center bracket hole
is centered between framesets.
Proceed to
Step 7.
Attach Feet to Legs
Attach Feet (B & BB) to all Legs using six 5/16- 18 × 5/8"
Button Head Socket Cap Screw (T). Make sure to use
the correct BUTTON HEAD Screws!
Note: Make sure the longer section of
the foot will face the front of the desk.
Tighten Securely.
a
a
a
a
d
a
a
a
a
b
c
c
c
c
d
d
c
b
b
c
b
4
5
B
T
T
Make sure longer
end of foot is facing
front of desk
Adjust Joining Brackets so middle hole
aligns with screw location.
Adjust Joining Brackets so
middle hole is centered.
BB
T
5/16-18 × 5/8" Button Head
Socket Cap Screw
Hardware at actual size
CAUTION! Be sure to use the correct
hardware for this step!
Your Frameset size and shape may differ
Note: Avoid trip or tip hazards!
For uniquely shaped, non-standard
worksurfaces, it is the installers
responsibility to position the
worksurface to minimize extended
overhangs and position feet fully
under the worksurface.
