2 of 12
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
WARNING:
Maximum loading of frameset is 390 lb. (177 kg.). Maximum load includes the weight of the table top
itself, any equipment placed upon it, and any equipment suspended or hanging under it. Loading should be evenly distributed over table
surfaces.
Rise 3-Leg
V = 120 VAC, 60 Hz
3.2 A maximum with single power supply
6.4 A maximum with a second optional power supply
Duty cycle: 1 minute on/ 9 minutes off.
IMPORTANT SAFETY INSTRUCTIONS:
When using an electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using this Rise Quiet Frameset.
DANGER:
To reduce the risk of electric shock, always unplug this Rise Quiet Frameset from the electrical outlet before cleaning.
CAUTION-RISK OF ELECTRIC SHOCK.
This unit may have two power cords. Unplug both cords before moving or servicing this
furnishing.
WARNING:
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Unplug from outlet (or outlets if equipped with a second power supply) before putting on or taking off parts, moving or servicing.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the
manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into
water. Return the furnishing to a service center for examination and repair.
5. Keep all cords away from heated surfaces.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
8. To disconnect, remove plug from outlet (or outlets if equipped with a second power supply).
9. Each Rise Quiet 3-Leg Frameset intended to support an equipment payload capacity of 390 lb.(177 kg.)
SERVICING OF DOUBLE-INSULATED PRODUCTS
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-
insulated product, nor is a means for grounding to be added to the product. Servicing a double-insulated product requires extreme care and
knowledge of the system, and is to be done by a qualified service personnel. Replacement parts for a double-insulated product must be identical
to the parts they replace. A double-insulated product is marked with the words “DOUBLE INSULATION” or “DOUBLE INSULATED”. The symbol
(square within a square) is also able to be marked on the product.
FOR COMMERCIAL USE ONLY
SAVE THESE INSTRUCTIONS
Verify that you have all the hardware and tools needed for the assembly
Check your cartons against the list above to verify that you have all the parts needed.
You will also need the following tools:
Drill/driver with #2 and #3 Phillips head bit
3/16" Allen bit for drill/driver
3/16" Allan Wrench provided
If you do not have a Workrite pre-drilled worksurface, you will also need:
⅛" drill bit
Tape measure
✓
An electric Drill/Driver is
recommended over hand
tools for this installation.
