18 of 18
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
#1500419 Rev A
Initialize Legs
After all Legs and Switches are connected, and Power In Feed has been plugged in, hold the
down arrow on Switch
until Legs make a short motion down and then back up. This initializes and synchronizes workcenter Legs.
Adjust Feet Glides
If necessary, adjust Leveling Glides on workcenter feet to level the worksurface. Unscrew to increase height,
screw in to decrease height.
You must complete this
initialization step or your
workcenter will NOT
function properly.
Hold down the down arrow until
workcenter moves slightly upwards!
Repeat for all Workcenters.
Cleaning Instructions
To clean the Sierra HX legs, apply cleaner to a soft cloth.
Suggested cleaners: Windex or Formula 409.
Do not use solvents and do not saturate or spray cleaners directly onto workcenter base.
Parts & Accessories
Visit
http://workriteergo.com/documentation/other/workrite_ergonomics_pricing_specification_guide.pdf
for
replacement parts.
Set Control Switch Initial Settings (For FDLX only)
20.1 Press the DOWN button to move table to its lowest position.
20.2 If using a worksurface other than a Workrite top, measure height of table from floor to top of worksurface.
If using a Workrite worksurface, the number to use will be 27.5".
20.3 Press and hold both the UP and DOWN buttons simultaneously. Three dashes will appear. Wait for the numeric
display to return.
20.4 Press the UP button until the display reads 27.5" (for Workrite worksurfaces) or measured height (for others).
20.5 The display will flash when the change has been saved.
20
18
19
✓
✓
