17
Locate the ceramic resistor on the speed control board (Image 16)
Image 16
Once the Resistor is located, remove it. Using a piece of wire or paper clip, jump the two open terminals the resistor came out
of (Image 17)
Image 17
Using the Digital meter in the VDC setting, repeat the testing seen in images 11 and 12. Start at 0 and move the belt speed control
to 100, if the full range of voltage ( 0 - 90vdc) is reached, the resistor will need to be replaced. If no change is seen in the voltage
and the belt still wont turn, either the speed control board or motor will need to be replaced.
Part
AJ
Resistor
