3730 E. Southern Avenue, Phoenix, AZ 85040 USA
800-778-8779
Workhorseproducts.com
28
Maintenance
Moisture in the air supply can reduce the efficiency of the printer and cause premature component failure.
Please ensure that the air dryer attached to your air supply is rated for the correct capacity. Component
failure caused by moisture in the air supply is not covered by the manufacturer warranty.
NOTE: Please ensure that the air being delivered to your press is free of any moisture. Workhorse Products
recommends the following maintenance be performed:
1. Regularly check the air dryer for proper operation.
2. Drain compressor daily.
3. Change the filter in the eliminator no less than every 4 months.
If milky fluid is observed in either side of your filter, regulator, lubricator (FRL) the air drying system has
failed!
Cycle Number
Recommended Maintenance
75,000
Grease center shaft and thrust bearing
250,000
Check print arm belt tension
200,000
Check compressor and dryer
100,000
Check fan intake on Flashback
300,000
Check flashback reflectors
To grease the center of the machine, there is one port
that will grease both the top and the bottom of the
wheel. After the first application rotate the tables a
few times and reapply.
WARNING!
RISK OF ELECTRICAL SHOCK! Turn ALL power to unit OFF before service
.
All service should be done by or under the supervision of a trained technician
