Satellite Upconverter Manual
WORK Microwave
8 / 49
V151207
1.5 Compliances
1.5.1 Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A device, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accord-
ance with the instruction manual, it may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference; in which case, users are required
to correct the interference at their own expense.
Note:
To ensure compliance, properly shielded cables for DATA I/O shall be used. More specifically, these
cables shall be shielded from end to end, ensuring a continuous shield.
1.5.2 Safety Compliance EN 60950
Applicable testing is routinely performed as a condition of manufacturing on all units to ensure compliance
with safety requirements of EN 60950.
This equipment meets the Safety of Information Technology Equipment specification as defined in EN 60950.
1.6 Safety Instructions
Please read this chapter carefully before you install and use this device from WORK Microwave.
To ensure your safety, please make sure you observe the following important points:
·
The equipment described in this manual is designed to be used by properly trained personnel
only!
·
Electrical safety:
If the information on electrical safety is not observed either at all to the extent necessary,
electric shock, fire and/or serious personal injury or death may occur.
1. Prior to switching on the product, always ensure that the nominal voltage setting on the prod-
uct matches the nominal voltage of the AC supply network. If a different voltage is to be set,
the power fuse of the product may have to be changed accordingly.
2. In the case of products of safety class I with movable power cord and connector, operation is
permitted only on sockets with an earthing contact and protective earth connection.
3. Intentionally breaking the protective earth connection either in the feed line or in the product
itself is not permitted. Doing so can result in the danger of an electric shock from the product.
If extension cords or connector strips are implemented, they must be checked on a regular
basis to ensure that they are safe to use.
4. For save operation, the ground terminal of the device must be permanently connected to a
grounding point. Otherwise, the device could be damaged.
