Satellite Upconverter Manual
WORK Microwave
7 / 49
V151207
1 Introduction
1.1 Application
The Upconverters from WORK Microwave are utilized in modern satellite communication and broadcasting
systems.
This document describes the functions, the installation and the monitoring and control interfaces (M&C) of the
Upconverters.
1.2 Reference Documents
The Upconverters of WORK Microwave are designed in correspondence with the following references and
standards:
EN 55022
EN 61000-6-2
EN 61000-6-3
EN 60950-1
IEEE 802.3
Universal Serial Bus Specification Revision 2.0
1.3 Reference to Firmware Versions
This issue of the user manual applies to the front panel base firmware version XNA01.58 or higher and the
front panel device firmware version FCA01.50.
The front panel base firmware version and the front panel device firmware version are shown immediately
after booting for approx. 2 sec. in the display. The firmware versions can also be queried by the front panel
menu: “SYSTEM CFG / FIRMWARE VERSIONS” or by the remote access.
1.4 Abbreviations
AC
Alternating current
BNC
Bayonet Neill Concelman
DC
Direct Current
EQ
Equalization
HTTP
Hypertext Transfer Protocol
HTTPS
Hypertext Transfer Protocol Secure
IC
Integrated Circuit
IF
Intermediate Frequency
IP
Internet Protocol
LCD
Liquid Crystal Display
LED
Light-Emitting Diode
LNA
Low Noise Amplifier
LNB
Low Noise Blockconverter
LO
Local Oscillator
M&C
Monitoring & Control
MAC
Media Access Control
MIB
Management Information Base
MPT
Multipoint
MW
Microwave
NTP
Network Time Protocol
OCXO
Oven-Controlled Crystal Oscillator
ODU
Outdoor Unit
OID
Object Identifier
OS
Operating System
PLL
Phase-Locked Loop
PLO
Phase-Locked Oscillator
Ref.
Reference
RF
Radio Frequency
RX
Receiver
SNMP
Simple Network Management Protocol
TCP
Transmission Control Protocol
TCXO
Temperature Controlled Crystal Oscillator
TX
Transmitter
UDP
User Datagram Protocol
USB
Universal Serial Bus
VFD
Vacuum Fluorescent Display
VHF
Very High Frequency
XML
Extensible Markup Language
