http://www.woosim.com
46
2) Any setting that exceeds the printable are is ignored
3) When pitch N is specified to the right; nL + nH x 256 = N
When pitch N is specified to the left (the negative direction), use the
complement of 65536.
4) The print starting position moves from the current position to [N x
horizontal or vertical motion unit)]
5) The horizontal and vertical motion unit are specified by GS P.
6) The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal
movement amount, and it must be in even units of the minimum horizontal
movement amount.
7) In standard mode, the horizontal motion unit is used.
8) In page mode, the horizontal or vertical unit differs as follows, depending
on the starting point of the printing area;
When the starting position is set to the upper left or lower right of the
printable area using ESC T, the horizontal motion unit (x) is used. When the
starting position is set to the upper right or lower left of the printable area
using ESC T, the vertical motion unit (y) is used.
[Reference]
ESC $, ESC P
ESC a n
[Name]
Select
justification
[Format]
ASCII
ESC
a
n
HEX
1B
61
n
Decimal
27
97
n
[Range]
0
˺
n
˺
2 , 48
˺
n
˺
50
[Description]
Aligns all the data in one line to the specified position. n selects the type of
justification
as
follows;
n
Justification
0, 48
Left justification
1, 49
Center justification
2, 50
Right justification
