9
Handlebar Components:
The display would normally be mounted on the left side. If you decide not to fit the throttle (a lot of peo-
ple don
’
t), then it is not necessary to fit brake cut
-
outs. If you are using throttle, you
will
need to fit one of
the three types of brake cut
-
outs: Levers (for cabled brakes), inline sensors (for cabled brakes), hydraulic
sensors which can also be used for cabled brakes in situations where the gear shifter and brake levers are
a single unit.
To fit the thumb
-
throttle & brake levers (if being used), slide the grips off, loosen the existing compo-
nents, and remove any that are being replaced, then slide the thumb
-
throttle (and levers if being used) in
place and then re
-
tighten the bolts to secure them in place. The display has a clamp, and so should be
fitted after the other components are in position. The throttle is universal and can be fitted to either side.
If you have hydraulic brakes or brake levers that have an integral gear shifter, you will need to use the hy-
draulic sensors. As the magnet moves away from the sensor, the cut
-
out is activated, it should be fitted as
shown below.
Sensor
Magnet
Inline Sensors: Feed the brake cable though as shown below
-
right. Be sure to use the plastic insert
between the sensor and barrel adjuster.
