-19-
Figure 27.
Aligning chisel to marked workpiece.
Figure 28.
Repositioning the support block.
Figure 29.
Support block locations.
ADJUSTMENTS
Wider Stock
1.
Remove the mortising chisel and drill bit.
2.
Loosen and remove the 2 hex nuts on the
top of the pivot base.
3.
Carefully lift the head stock assembly until
pivot base clears the locking studs. Lay the
assembly on its side on the workbench.
4.
Remove the 3 cap screws holding the sup-
port block to the pivot base as in
Figure
28
.
Note that the support block is in position
A
(in
Figure 29
) when the block is closest to the fence
and position
B
when the block is furthest from
the fence.
5.
Reposition the support block to position
B
.
6.
Reattach the support block with the 3 cap
screws.
Reattach the head casting assembly and follow
the instructions above for fence and workpiece
setup.
5.
Place the workpiece against the fence and
position the fence so the chisel is near the
penciled in marks. Lock the fence.
6.
Loosen the setscrew holding the micro adjust-
ment block on the fence mounting rod and
move the block until the screw fits into the
back of the support block.
See Figure 26 on
the previous page.
7.
Unlock the fence and rotate the micro adjust-
able knob until the chisel lines up withthe
penciled in lines as in
Figure 27.
