thermocouple are properly connected to both the pilot
assembly and gas controller (see illustration 9.5).
8. Check that the piezo wire is connected to the pilot assembly
and igniter button (see illustration 9.5). Press the Red
Ignition Button to test for spark in the Firebox near the pilot.
CAUTION: Sheet metal edges are sharp. Please handle carefully
1. INSTALLING THE LOGSET
Remove the front casting and glass front – see illustrations 9.1
and 9.3 for details. Place the Logset over the five positioning tabs
on the Burner Pan. Push it as far back as it will go toward the rear
of the Firebox.
If you own a Natural Gas Fireplace then your logset will sit on
top of the Air Shield and not directly on the tabs. The air shield
should sit flat on the (2) front tabs. The sides must be pushed
down into position. Be sure that the sides of the air shield do not
hang up on the inside walls of the firebox.
Make sure that the front edge of the Logset sits behind the two
metal tabs on the front edge of the Burner Pan.
It is important that the rear of the logset be positioned
against the rear of the firebox. Due to variance in size with
each Logset the front edge of your Logset may not touch the
upright section of the front tabs.
Ensure that the Logset is sitting flat on the rear tabs on the
Burner Pan (Air Shield for NG owners) by gently pushing down
on the rear of the logset and making sure it is not hung up on the
sides of the Firebox.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ 14
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Assembling the Fireplace
Illustration 9.3
The glass front
is held in place by four spring-
loaded clips. To release the
clips, pull and twist.
Gas Manifold
Illustration 9.4
The burner pan fits
in the base of the Fireplace as
illustrated. On Natural Gas models
an air shield is installed over the
burner.
Illustration 9.5
These connections
should be checked carefully.
10. ASSEMBLING THE FIREPLACE
Illustration 10.1
Place the logset
against the back wall of the
firebox. Center the logset from
side to side. The logset air shield
is located between the ceramic
logset and the burner on natural
gas models only.
logset air shield (NG only)
Illustration 9.2
Gas Pilot Tube
Thermopile Connector
Thermocouple
Connector
To Igniter Button
Piezo
Wire
