Woodstar 3908203952, Оригинальное руководство, Страница: 25 / 40

GB / 25
• Clean the device with a clean cloth, or blow
it out with compressed air at low pressure.
• All moving parts are to be re-greased at
periodic intervals.
• Do not use detergents or solvents as these
might damage the plastic parts of the de-
vice. Make sure that no water can get in-
side the device.
CARBON BRUSHES
In case of excessive sparking, have the car-
bon brushes checked by a qualified electri -
cian.
Caution! The carbon brushes should be re-
placed only by a qualified electrician.
ADD LUBRICATING GREASE (FIG. 5, 6)
The machine must be lubricated with the
grease that is provided after approximately
50 hours of operation.
Switch off the machine and pull the mains
plug out of the socket.
• Undo the cover (6) by using the spanner
(7).
• Remove the cover on the top of the ma-
chine.
• Lubricate all the accessible mechanical
parts with a prox. 50 g of grease.
• Tighten the cover (6) again.
Important: The waste grease must be
disposed of in the appropriate collection
point for waste grease.
ORDERING SPARE PARTS
When ordering spare parts, the following in-
formation should be provided:
– Type of device
– Article number of device
– Spare part number of the part required
Electrical connections must comply with the
relevant VDE and DIN regulations. Only use
connecting cables with H 07 RN mark.
An imprint of the type designation on the
power cable is mandatory.
Faulty power supply cables
Insulation damage often occurs at power
supply cables.
Causes are:
• Pressure points when power supply ca-
bles are routed through the window or
door gaps.
• Bends due to improper fastening or guiding
of the power supply cables.
• Interfaces by running over the power sup-
ply cables.
• Insulation damage by pulling off the wall
outlet.
• Cracks due to ageing of the insulation.
Such defective power supply cables must not
be used and are extremely
dangerous to life
because of the insulation damage!
AC motor 230 V / 50 Hz
Mains voltage 230 V / 50 Hz
Power supply and extension cord must be
3-wire = P + N + SL. - (1/N/PE).
Extension cables must have a minimum
cross section of 1.5 mm².
The mains supply is secured up to 16 A.
Maintenance
CLEANING
Caution! Disconnect the mains plug!
• Clean the machine each time after com-
pleting work.
• The machine should be cleaned regularly
to remove dust and dirt.
• Keep safety devices, air vents and the mo-
tor housing as dust and dirt-free as pos-
sible.