INSTALLATION, OPERATION & MAINTENANCE
INSTALLATION, OPERATION & MAINTENANCE
INSTALLATION, OPERATION & MAINTENANCE
INSTALLATION, OPERATION & MAINTENANCE
Woodson Contact Toaster –W.GPC61SC
Tel: 1300 79 1954 Web: www.stoddart.com.au Email: [email protected]
Page 12 of 23
Due to continuous product research and development, the information contained herein is subject to change without notice
Operating Instructions
1.
Visually check the toaster is clean, in good repair and safe.
2.
Ensure that the top platen is in a closed position.
3.
Turn the power switch to the desired mode i.e. Top and bottom platen for normal press toasting, Bottom platen
for Griddle style operation or Standby. The power “ON” indication light located on the L/H side control panel
and Power ready light will be illuminated. If the indicator light does not illuminate refer to the trouble shooting
section of the manual.
4.
Allow the press toaster to preheat for approximately 30 minutes. The temperature ready indicator light will
turn itself OFF once the press toaster has reached its optimum operating temperature. The press toaster is
preset to operate between 205°C - 210°C surface cooking temperature.
5.
Ensure that the 4 display timers are set to the desired cook time on the control panel (
refer to
programming
the toaster instructions in this manual).
6.
Lift the top platen up to a fully open position by the handle provided.
7.
The top platen will remain in the open position, as it is spring-loaded.
8.
Take extreme care when lifting, do not touch the cover or cooking surface to avoid skin burns.
9.
Place the food product onto the cooking surface and close the top platen.
10.
Ensure that the product is placed centrally of the cooking surface, to prevent the top platen from tilting and
producing uneven product.
11.
Press the appropriate display timer button (i.e. 1,2,3,4) to start the cooking procedure. The time shown in the
window above the corresponding button will begin to count down.
12.
Once the count down timer reaches
“000”
, the timer will emit a beeping sound. Press the appropriate display
timer button again, to de-activate the timer. Lift the top platen fully to the open position and remove the
toasted product.
13.
Replace the top platen back in to the down position when the product has been removed.
14.
Periodically check the crumb tray mounted at the front of the press toaster, to ensure it does not overflow.
Take extreme care when removing the crumb tray, ensure you grab the crumb tray handle using heat resistant
gloves and do not touch the cooking surface to avoid skin burns.
NOTE!
Do not use the press toaster until the temperature ready light is off, as you will not
achieve optimum product quality results.
NOTE!
The timer can be stopped if necessary, by pressing the timer button and holding it for 3
seconds.
NOTE!
To ensure optimum product quality, the top platen must be closed
after every operation of unit, to maintain constant temperature.
Power on light
Timer buttons
Temperature ready light