Page 12
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Troubleshooting
Task Type - (O) = Operator
(T) = Technician Task
Problem
Possible Causes
Task
Possible Corrective Action
Unit won’t turn on
Unit is not plugged into a suitable
power point
O
Plug unit in
Power switch is in the “Off” position
O
Change the power switch to the “ON” position
Power Point is faulty
T
Arrange a qualified Technician to repair the power point
Conveyor not turning on
Conveyor Motor faulty
T
Lubricate / replace conveyor motor
Conveyor speed dial not responding
T
Replace speed dial / Computer board (whichever is applicable)
Loose drive sprockets
T
Tighten sprocket grub screws
Conveyor chain binds up in
operation
Sprocket worn
T
Replace sprocket
Belt loose
T
Remove a chain link
Unit is overheating
Airflow blockage
O
Clear dirt / dust from fan guard and/ or clear all air vents around the
unit of any obstructions
Fan not working
T
Replace fan
Unit is not heating
Elements not working
T
Replace Elements as required
Temp switch not working
T
Replace switch
Product is burning
Conveyor too slow
O
Adjust speed settings as required
Product is undercooked
Conveyor is too fast
O
Adjust speed settings as required
WARNING
Technician tasks are only to be completed by qualified service
people. Check faults before calling service technician.
• If any faults/issues occur with the unit, follow the below troubleshooting procedures
• If the troubleshooting procedures do not correct the problem, contact the Stoddart Service Department
Cleaning and Maintenance
