Page 7
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Installation
Three Phase Units 3Ø + N + E:
• W.CVP.C.18 (15A 3Ø + N + E)
- Supplied with 2 metre lead, no plug for 5 wire 3Ø + N + E hard wiring on site by a qualifi ed electrician
- Optional factory fi tted plug is available (W.CVS.PL32.3PH)
• W.CVP.C.24 (20A 3Ø + N + E)
- Supplied with 2 metre lead, no plug for 5 wire 3Ø + N + E hard wiring on site by a qualifi ed electrician
- Optional factory fi tted plug is available (W.CVS.PL32.3PH)
On-site Connection:
• The electrical supply must comply with the rating plate data
• Ensure that the machine is connected to a suitably rated power source
• Disconnection must be incorporated in the fi xed wiring in accordance with the wiring rules
• To connect the power, the unit has a terminal block supplied inside the service compartment
This unit must be installed in accordance with AS/NZS 60335.1
Some procedures in this manual require the power to the equipment to be turned off and
isolated. Turn the power OFF at the power point and unplug the power supply lead by the plug
body. If the power point is not readily accessible turn the equipment off at the isolation switch
or the circuit breaker in the switchboard. Attach a yellow “CAUTION-DO NOT OPERATE” tag.
This must be performed where relevant unless the procedures specify otherwise.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
WARNING
Notes:
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a
hazard. Please contact Stoddart for parts and we will advise how to do this in order to avoid any electrical hazard
• The power cable should be dry and/or isolated from moisture or water
Electrical Connection
Information
