Woods BATWING BW13.70, Руководство оператора

Страница: 32 / 92

32 Dealer Service
MAN1281 (4/15/2019)
Gearbox Inspection
1. Check gearbox for leaks by: plugging all holes
except one, applying 4 psi of compressed air, and
immersing gearbox in water. Verify gearbox does
not leak.
NOTE: Excessive air pressure will damage seals.
2. Remove gearbox from water and dry off.
3. Remove upper plug on right side of housing. Add
SAE 80W or 90W EP oil until it runs out side level
hole. Replace plug.
4. Install breather (24) in top cover.
Gearbox Installation
NOTE: Gearbox is heavy: do not attempt to move it
without mechanical assistance.
1. Place gearbox on cutter and secure into position
using four cap screws and lock washers.
2. Torque hardware to 300 lbs-ft.
3. Attach all drivelines to gearbox.
4. Install all shields.
Figure 14 . Splitter Gearbox Assembly
2. 10 mm Lock washer
3. M10 x 1.5P x 30 HHCS
4. Input cap
5. Input shaft
6. Input oil seal
7. Bearing assembly (cup & cone)
8. Gasket .15 mm
9. Gasket .25 mm
10. Gasket .40 mm
11. Hub cap
12. Oil seal
13. Output shaft
14. Spacer
15. Shim .30 mm
16. Shim .40 mm
17. Shim .50 mm
18. Center gear
19. Wing gear
20. Bearing adjustment nut
21. 1/8 x 2-1/2 Cotter pin
22. Sealing washer
23. M18 x 1.5P Level plug
24. M18 x 1.5P Breather plug