P1-DC3: #35123
Rev 5.2/12-21
34
C07
“Control head revision lockout”
continuous
(while button
is held)
(none)
Once “Power Save” mode is activated, “attach” and
“release” functions are prevented in connection with Code
C06. Service is required.
E00
E01
E02
E03
E04
“EEPROM error, cell #”
occasional
chirp
(none)
Memory error detected. Service is required.
I000
“I2C error (#)”
single chirp
(none)
If code does not clear automatically , service is required.
N00
“Automatic attach”
(none)
(none)
System activated “attach” mode as precaution because
significant vacuum was detected, even though no one
initiated “attach” function. No corrective action is
necessary.
N01
“Automatic attach”
(none)
(none)
System activated “attach” mode as precaution because
load did not release completely. No corrective action is
necessary.
N02
“Automatic attach”
(none)
(none)
System activated “attach” mode as precaution when lifter
was powered up because power was previously lost while
load was attached. No corrective action is necessary.
N03
“Unable to turn module power
off”
1 chirp every
2 seconds
(none)
Remove 9V battery. Disconnect connector between 12V
battery and vacuum generating system. Charge battery
completely (see
). Then
reconnect battery and try to power down again.
If code persists, disconnect connector. Service is required.
N04
“Failed to turn controls power
off”
1 chirp every
2 seconds
(none)
Remove 9V battery. Disconnect connector between 12V
battery and vacuum generating system. Charge battery
completely (see
). Then
reconnect battery and try to power down again.
If code persists, disconnect connector. Service is required.
N05
“Unable to turn module power
on”
1 chirp every
2 seconds
(none)
Charge 12V battery (see
). Then
power lifter up again. If code persists, service is required.
N06
“Power-down reminder”
2 chirps
on
briefly
Power down to prevent 12V battery discharge when lifter
is not in use.
N07
“Auto power-down disabled”
(none)
(none)
Automatic power-down is prevented. Power lifter down
and up again. If code persists, service is required.
N08
“powering down in # seconds”
1 chirp per
minute
(none)
Lifter will automatically power down in number of seconds
shown. Press any button to cancel action.
N10
“App-support hardware fault”
(none)
(none)
Fault is detected in hardware that enables communication
with mobile app. Power lifter down and up again. If code
persists, service is required.
U00
“WARNING! Is load attached?”
fast chirp
on
Attempt was made to power down lifter while load was
still detected. Lower load onto stable support and release
load
before
powering down lifter.
U01
“Also hold [Fn] to power down”
(none)
(none)
Hold “function” button and “power” button at same time
to power down lifter.
Code
On-Screen Message
Buzzer
Pattern
Strobe
Light
Activity
Explanations/Directions
MAINTENANCE
Содержание 98720
Страница 2: ...P1 DC3 35123 Rev 5 2 12 21 2 ...
Страница 6: ...P1 DC3 35123 Rev 5 2 12 21 4 SPECIFICATIONS Note A standard P11104DC3 is shown ...
Страница 42: ...P1 DC3 35123 Rev 5 2 12 21 40 ...
Страница 43: ...Rev 5 2 12 21 P1 DC3 35123 41 ...
