Woodpeckers LED.D, Инструкция по эксплуатации, Страница: 15 / 24

13
in order not to affect the light intensity.
8.11 This equipment will be off automatically if no action occurred
within 2 minutes. Turn it on by pressing any button.
8.12 The effective light intensity of this equipment is much higher than
halogen lamp curing light. The solidified depth of the composite resin is
no less than 4mm if irradiated by this equipment for 10 seconds.
8.13 The optical fiber should be sterilized for 4 minutes with 134
℃
and
2.0bar~2.3bar (0.20MPa~0.23MPa) before each use.
8.14 The curing light is equipped with over-heat protection system. It
can continuously work 200s, For example, continuously operate the
curing light for 10 times under 20s working mode (even the curing light
works less than 20s, it is counted as a full operation), then it will come
into over-heat protection status. And only after 2-minute sleep, it can
restart working 200s continuously.
9. Maintenance
9.1 This equipment does not include the self-maintenance parts, so it
should be performed by professional or special maintenance shop.
9.2 The optical fiber should be sterilized for 4 minutes with 134
℃
and
2.0bar~2.3bar (0.20MPa~0.23MPa) before each use, other parts should
be cleaned by clean water or neutral sterilized liquid, but do not soak
the equipment in the water. Do not clean by volatile or soluble liquid,
otherwise the marks of the control panel will fade.
9.3 Please clean the optical fiber to avoid the remaining resin on the
surface and infect the life-span and the effectiveness of solidification.
10. Transportation
10.1 Excessive impact and shake should be prevented in transportation.
Lay it carefully and lightly and don't invert it.
10.2 Don't put it together with dangerous goods during transportation.