WoodFast M320, Инструкция по эксплуатации

Страница: 9 / 14

-9-
4.4 KNOCKOUT BAR
- The knockout bar is used to remove the spur center
from the headstock spindle. Insert knockout bar into hole
at opposite side from spur center.
Fig.4.4
4.5 ATTACHING LIVE CENTER ON THE
TAILSTOCK
- Insert the live center, with a No.2 Morse Taper shank
into the tailstock spindle.
TAILSTOCK HAND WHEEL
TAILSTOCK SPINDLE
TAILSTOCK’S TOP
Fig.4.5
- To remove live center from the tailstock spindle, loosen
locking arm and rotate the hand wheel counterclockwise
to retract spindle into the body of the tailstock. The live
center will be pushed out of the spindle.
4.6 INSTALL THE FACEPLATE TO THE
HEADSTOCK
- Thread the faceplate clockwhise onto the headstock
spindle. Next, tighten faceplate with supplied wrench.
4.7 INSTALL TOOL HOLDER ON THE LATHE
BED
- Located the tool holder from the carton, and install it
onto the lathe bed with two pan head screws.
TOOL HOLDER
PAN HEAD SCREW
Fig.4.7
TOP BAR
Fig.4.6