WoodFast M320, Инструкция по эксплуатации

Страница: 11 / 14

-11-
6. MAINTENANCE
CAUTION!
BEFORE CLEANING OR CARRYING OUT MAINTENANCE WORK, DISCONNECT THE MACHINE
FROM THE POWER SOURCE (WALL SOCKET). NEVER USE WATER OR OTHER LIQUIDS TO
CLEAN THE MACHINE. USE A BRUSH. REGULAR MAINTENANCE OF THE MACHINE WILL
PREVENT UNNECESSARY PROBLEMS.
- Keep the lathe bed casting clean and lubricated.
- Keep the outside of the machine clean to ensure accurate operation of all moving parts and prevent excessive wear.
- Keep the ventilation slots of the motor clean to prevent it from overheating.
- Remove all saw dust and chips from the lathe after each use.
7. TROUBLE SHOOTING
WARNING!
FOR YOUR OWN SAFETY, ALWATS TURN OFF AND UNPLUG THE MACHINE BEFORE
CARRYING OUT ANY TROUBLESHOOTING
Symptom Possible Cause Solution
Motor will not
start Machine not plugged in
Low voltage
Loose connection Plug the machine in
Motor
overheats Motor overloaded
Air flow restricted on motor Reduce load on motor
Clean out motor to obtain normal air flow
Excessive
motor noise Bad motor
Pulley set screw loose Have motor checked
Tighten set screw
Motor will not
develop full
power or stalls Circuit overloaded with lights or other tools
Circuit too long or undersized wires
Voltage too low
Circuit breakers do not have sufficient capacity
Drive belt tension too high
Use of extension cord Decrease the load on the circuit
Reduce the length of the wire or increase the wire
size
Have the voltage checked by an electrician
Have a licensed electrician install proper size
breaker
Adjust belt tension
Use heavier gauge extension cord or no extension
cord
Machine bogs
down during
cutting Excessive deoth of cut
Turning tools are dull Decrease depth of cut
Sharpen turning tools
WARNING!
Do not make adjustments while the lathe is running,Ensure the switch is off, power is disconnected
and all moving parts have stopped before servicing.Failure to comply may result in serious injury.