Cascade Gas-Fired Rotisserie
Installation and Operation Manual
PG
19
OF
28
M0049.08 MARCH 2018
An ongoing program of product improvement may
require us to change specifications without notice.
WOOD STONE CORPORATION
1801 W. Bakerview Rd.
Bellingham, WA 98226 USA
TOLL FREE
800.988.8103
TEL
360.650.1111
FAX
360.650.1166
woodstone-corp.com
PREVENTIVE MAINTENANCE
Contact the Wood Stone Service Department or a qualified local service company for any maintenance or repairs.
NOTE:
ALWAYS DISCONNECT POWER SUPPLY BEFORE SERVICING THIS APPLIANCE.
MAIN BEARING LUBRICATION (EVERY 12 MONTHS)
The two main shaft bearings should receive one pump of a NLGI Grade 2 lithium-based grease, such as Lubriplate 630-2, every
12 months� These bearings are located inside the cabinet on either end of the main shaft� A Zerk fitting for each bearing is
located directly below the top door hinge on either side of the cabinet on the operator (door) side� Care should be taken not to
over lubricate these bearings� One pump is sufficient�
MOTOR BRUSHES REPLACEMENT (APPROXIMATELY EVERY 3 YEARS)
The three year replacement recommendation is based upon an average daily use of 10 hours� Contact the Wood Stone Service
Department or your local service technician for service�
REDUCTION GEAR LUBRICATION
The gearbox is permanently lubricated and requires no additional maintenance�
SPUR GEAR BUSHING
Check the spur gear bushings for signs of binding or lateral movement where the gear shank passes through the drive end drum�
The gear should rotate in the Rulon inner bushing� If the gear and Rulon bushing are rotating in the drum sleeve instead, remove
the gears and Rulon bushings, clean and refit� Do not lubricate the bushings or gears� To remove the gears, first mark the drum in
relation to the shaft to ensure it is reinstalled in the same position� Remove the six bolts that retain the drum end to the hub and
slide the drum end assembly toward the center of the cabinet� The spur gears can now be removed by loosening the set screw
retaining the locking collar and sliding the gears out of the drum�
INNER DRUM SEALING
The condition of the high-temperature sealant used to seal the inner drums to the cabinet walls and the inside corners of the
cabinet should be checked and renewed if sealant has failed� Use Dow Corning 732 RTV sealant�
DOOR JAMB MICRO SWITCH
Check the jamb switch for proper operation� The switch should move freely in the jamb without sticking or binding and the drums
should stop when the doors are opened�
SPEED CONTROL KNOB
Check the speed control potentiometer for proper operation and the knob for tightness�
DOOR LATCH
Check the door latch mechanism for proper operation� If sticking occurs, remove the wedge pin, clean, refit and adjust�
EXHAUST HOOD
Refer to the exhaust hood manufacturer’s recommendations for inspection, maintenance and cleaning�
