Wood Pellet Products WPPH001.3, Руководство пользователя

Страница: 6 / 10

Also included in the box is a hardware bag that contains:
¼” bolts (for (M) Door to (L) Door mounting bracket)
¼” nuts ( for (V) screw in feet, for securing (Q) Ash pan handles and hopper handles (not pictured)
¼” washer ( for (V) screw in feet)
¼” lock washers (for (Q) Ash Pan Handle and hopper handles (not pictured)
10/32” bolts for mounting the (F) Hoppers to (K) Firebox. 10/32’’ nuts with #8 washers for (Z)
Pyroceram Window to the (M) Door
10/32” bolts for securing (B) Stove top to (K) Firebox,
for securing (A) Stove top collar to (B) Stove top, for securing (D) Heat Baffle to (K) Firebox, for
securing (J) Firebox bottom to (K) Firebox, for securing (H) Rear Hopper Brackets and (G) Front
Hopper brackets to (K) Firebox, for securing (L) Door Mounting Brackets to (K) Firebox, for securing
(E) Air Chutes to (K) Firebox
10
/32” nuts/bolts for securing (Y) Top Reflector to (X) Stove Pipe Spark Arrestor.
10
/32” washers/nuts for securing the (Z) Pyroceram Window to the (M) Door.
Spring Handles (2)
Self-Taping Sheet Metal Screws
Lay out and identify all the heater parts.
1.2 Assembly Instructions
Step 1 Installing the Bottom Heat Shield and the Feet. Position the (U) Bottom Heat Shield in
place over the four holes on the b
ottom 1” flange of the firebox. Install four (V)Screw in Feet on the
bottom 1” flange of the (K) Firebox. Place washer over plastic washer on feet, then insert into holes.
Attach using
¼” washers and nuts.
Step 2 Installing the Hopper Brackets and Heat Shields. Attach (H) Rear Hopper Brackets using
one 10/32” bolt each.. Attach (G) Front Hopper Brackets using two 10/32” bolts each. Install (T) Heat
Shields by sliding heat shield in between the hopper and fire box so that the tabs are inserted into the
slots of the hopper bracket. The large tab on the bottom of heat shield should be facing the fire box.
Step 3 Installing the Hoppers. Place (F) Hopper pellet chute into hole in side of (K) Firebox. While
inserting pellet chute into hole, pull (T) Heat Shield towards (F) Hopper until the flange on the hopper
clears the heat shield. Use 10/32” bolts and nuts to secure Hopper flange to the(K) Firebox. Make
sure that the punch out in the hopper wall sets all the way down into the slot on the hopper brackets.
Step 4 Installing the Air Chutes. Place (E) Air Chute inside (K) Firebox by sliding the (E) Air
Chute under the protruding Hopper Pellet Chute and over the air slots that are cut into the side of the
(K) Firebox. Secure with two 10/32” bolts.
Step 5 Installing the Fire Grate and the Fire Box bottom. Insert (I) Fire Grate into (J) Firebox
Bottom. Install (J) Firebox Bottom in the (K) Firebox. The diagram shows the (J) Firebox bottom at the
top of the Firebox, but it is installed through the ash pan opening and is bolted in place just above the