Wood-mizer SW-10 SETWORKS, Руководство пользователя

Страница: 30 / 39

OPERATION
Pattern Modes
2
2-14 SW-10doc111419 OPERATION

Finish activating of the program by pressing . If the head return height was preset, the ’’Height”
light will come on indicating that this value was saved.
CAUTION! Remember to set the head at the first cut height before you finish
activating of the program.

Start the cutting process. When cutting, use the and buttons, as in the
normal mode.
Example:
In this example we have a log with three sides flat and we want to finish with a 100mm x 100mm cant and
get three boards - 50mm, 28mm and 25mm. ”Through and through” cutting procedure (without removing a
board after each cut) will be described.

Position the head a little above the log.

To enter the programming mode, press and hold . The ’’Program” light will come on and ’’P- 1”
will appear on the display.

Using the keypad, enter the first board thickness value (100) and press . Enter the next board
thicknesses (50, 28 and 25mm); each time confirm the setting by pressing .

Press and the head will move to the first cut height.

Raise the head so that it clears the log along its entire length.

Press . The ’’Height” light will come on, indicating that the head return height has been stored.

Cut the material using and , as in the normal mode of operation.
(
See Section 2.3
.)

After cutting the last board,
’’End pro”
will be shown on the display to indicate the end of cutting.