Setup & Operation
Loading, Turning, and Clamping Logs
Setup & Operation
HDSdoc091108
2-18
2
To Clamp Logs
4.
1.
Raise the clamp in/out lever and clamp the log against the side supports.
2.
Lower the turner lever until the turner arm falls below the bed.
3.
When the turner arm is lowered all the way, the side supports will begin to lower. Back the clamp
off slightly, and let the side supports come down until they are positioned below the level of your
first few cuts.
To Level A Tapered Log
Use the toe board lever(s) to raise either end of a tapered log, if desired.
Raise the appropriate lever to raise the front or rear toe board until the heart of the log measures
the same distance from the bed rails at each end of the log.
Pull-Down Clamps
When a cant is being cut, internal stress in the wood may cause the cant to deform slightly. The
cant with internal stress tends to raise on ends. To prevent this, use two additional Pull-Down
clamps. These clamps are mounted at both bed frame ends and if necessary hold the cant down
so it lies flat on the bed.
Содержание LT40 DH
Страница 1: ......
Страница 2: ......
Страница 69: ...Maintenance Carriage Track Wiper Scrapers Maintenance HDSdoc091108 3 5 3 FIG 3 3 ...
