Maintenance
Vertical Mast Rails
3
3-5
HDSdoc030722
Maintenance
3.5
Vertical Mast Rails
Clean and lubricate the vertical mast rails every 50 hours of operation. Clean with solvent
and remove any rust with a light-grade sand paper or emery cloth. Lubricate the mast with motor oil
or automatic transmission fluid (ATF).
CAUTION!
Never use grease on the mast rails as it will collect
sawdust.
3.6
Drum Switches
Lubricate the up/down and power feed drum switch contacts inside the control panel every fifty hours
of operation. Use only contact grease supplied by Wood-Mizer. Remove the control panel cover.
Use a cotton swab to apply grease to the switch contact ends.
WARNING!
Drum switch grease contains Petroleum Hydrocarbon
Lubricant. Eye and skin irritant. If introduced into eyes, flush with water
for at least 15 minutes. If film or irritation persists, seek medical
attention. Wash skin with soap and water. If ingested, do not induce
vomiting - contact a physician. KEEP OUT OF THE REACH
OF CHILDREN.
3.7
Miscellaneous
1.
Apply a thin film of a NLGI No. 2 grade lithium grease to the blade guide arm every fifty hours of
operation to help prevent it from rusting.
2.
Grease the clamp mechanism, loading arm, and side supports with a NLGI No. 2 grade lithium
grease every fifty hours of operation.
3.
Oil all chains with Dexron III ATF every fifty hours of operation.
CAUTION!
Do not use chain lube. It causes sawdust buildup in chain
links.
4.
Lubricate the board return pivot every fifty hours of operation with a NLGI No. 2 grade lithium grease.
Apply grease to the grease fitting on the board return pivot tube.
5.
Check the mill alignment every setup. See Section 5, Alignment.
6.
Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any damaged
or unreadable decals immediately. Order decals from your Customer Service Representative.
7.
Lubricate the clutch lever bushings every 200 hours of operation (or once a month). Apply lithium
grease to the fitting.
50
50
50
50
50
50
Содержание LT40 AH Series
