Sawmill Operation
Water Lube Operation
Sawmill Operation
HD97doc041910
4-21
4
4.11 Water Lube Operation
The Water Lube System keeps the blade clean. Water flows from a 5-gallon (18.9 liter)
bottle through a hose to the blade guide where the blade enters the log. A valve in the
bottle cap controls the amount of water flow.
See Figure 4-11.
Not all types of wood require the use of the Water Lube System. When it is needed, use
just enough water to keep the blade clean. This saves water, and lowers the risk of stain-
ing the boards with water. Usual flow will be 1-2 gallons (3.8-7.6 liters) per hour.
Before removing the blade, engage the blade. Let the blade spin with water running on it
for about 15 seconds. This will clean the blade of sap buildup. Wipe the blade dry with a
rag before storing or sharpening.
For further lubrication benefits, add one 12oz. bottle of Wood-Mizer Lube Additive to 5
gallons of water. Wood-Mizer Lube Additive enables some previously impossible timbers
to be cut by significantly reducing resin buildup on the blade. It helps to reduce heat
buildup, wavy cuts, and blade noise. This biodegradable and environmentally friendly
pre-mix includes a water softener additive, so it works with hard water.
WARNING!
Use ONLY water and Wood-Mizer Lube Addi-
tive with the water lube accessory. Never use flammable
fuels or liquids such as diesel fuel. If these types of liquids
are necessary to clean the blade, remove it and clean with
FIG. 4-11
Turn valve counterclockwise
to open; Clockwise to close
3H0129
