Wood-mizer HR1-6E11S, Инструкция по безопасности, эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 103 / 184

Alignment
Blade Guide Arm Vertical Adjustment
MHdoc092116 5-10
5
5.5 Blade Guide Arm Vertical Adjustment
1. Adjust the blade guide arm out to within 1/2" (15 mm) of full open.
2. Measure the distance from the top surface of the feed track to the arm.
See Figure 5-10.
3. Adjust the blade guide arm in to within 1/2" (15 mm) of full closed. Measure again the
distance between the arm and the feed track.
4. Adjust the arm so that the measurement from the top of the track feed to the arm in the
closed position is the same as the measurement from the top of the track feed to the arm
in the open position.
If the arm is too low in the closed position, loosen the lower outside roller and tighten the
upper outside roller. (See Step 5.)
If the arm is too high in the closed position, loosen the upper outside roller and tighten the
lower outside roller. (See Step 5.)
5. The rollers are mounted on cam bolts that raise or lower the arm when turned.
FIG. 5-10
Turn outside rollers to
raise or lower end of
the blade guide arm