Operation
3" Blade Support Setup (Option)
Operation
SISdoc052814
2-2
2
3.
Adjust the pusher pin. To adjust, manually rotate the pusher adjustment knob. Turn the
pusher adjustment knob clockwise to increase the pusher pin force, turn the knob coun-
terclockwise to decrease the force. Make sure the tooth is not being bent too much. Read
the display to check the tooth set while adjusting.
IMPORTANT!
Avoid pinching fingers or hand when turning
the cam.
DANGER!
Keep all persons away from moving parts when
operating this machine. Failure to do so will result in serious
injury.
4.
Adjust the index ramp. The push pawl should push one tooth at a time. To adjust, loosen
the blade ramp set screw. Slide the blade ramp as necessary and retighten the set screw.
The pawls should contact the point of the tooth where the face and gullet meet. Manually
rotate the index cam until the pawl is against the tooth radius. Loosen the index pawl
adjustment nut to position the pawl as necessary. Retighten the nut when adjustment is
complete.
2.2
3" Blade Support Setup (Option)
See Figure 2-2.
1.
Position the optional blade supports on proper sides of the toothsetter. Using the
connectors (1), connect the right and left blade supports with the toothsetter arms.
2.
Position the blade support kits so that the blade is not too loose and moves freely during
the setting operation.
3.
Install the bushings (2) on the guide assembly (3) - see Detail B in the figure below.
Adjust the height of the third blade support (5) and rest the toothsetter arm (4) on this
support.
4.
The blade supports should be adjusted vertically so that the bottom of the blade is at the
same height along entire length of the blade.
