Setup & Operation
Operation
3-18
DS12doc060917
Setup & Operation
3
Auto Feed Operation
Push the START - JOG button to advance the setter until the setter assemblies open. Pull
the clamp handle open and position the blade against the index arm pin with a rear-set
tooth aligned with the right setter block.
NOTE:
Most blades manufactured by Wood-Mizer are
made so the set pattern across the weld is consistent with
the rest of the blade. When this is the case, you can start
setting teeth anywhere on the blade and the Auto Feed will
automatically stop when the counter reaches the tooth total
entered. If the set pattern across the weld is not consistent,
start the blade with the weld to the left of the left side setting
clamp and end the cycle when the weld gets to the right of
the right setting clamp. To prevent resetting the teeth in the
opposite direction, count the number of teeth between the
two clamp blocks, subtract the number from the total quan-
tity of teeth on the blade, and enter the result in the setter
tooth counter. Use the provided bend back tool (023774) to
set the teeth that are between the setter clamps.
Push the clamp handle closed. Enter the appropriate number of teeth on the counter.
Push the lower buttons to adjust the counter setting.
See Table 3-1.
The quantity of teeth on any particular blade depends on the length and
tooth spacing of the blade. Common blade tooth quantities are provided below.
Tooth Spacing
0.656”
0.875”
1.125”
Blade
L
e
ngt
h
144”
220
165
128
158”
241
180
140
178”
272
203
200
184”
280
210
163
205”
312
234
182
No. of Teeth
TABLE 3-1