Wood-mizer 1987 LT30, Инструкция по безопасности, установке, эксплуатации и техническому обслуживанию

Страница: 107 / 112

Sawmill Alignment
Aligning The Pivot Bed Rails
Sawmill Alignment 3087doc041610 5-23
5
5.17 Aligning The Pivot Bed Rails
The two pivot bed rails are used when long cants are cut. (Long cants will often bend
down at the ends.) The pivot bed rails need to be adjusted to the same level as the main
bed rails. To adjust the pivot bed rails:
1. Adjust the pivot rail 90° to the main bed tube.
2. With the saw head raised so the blade is 14 3/4" from the main bed rails, move the saw
head so that the blade is over one of the pivot bed rails.
3. Measure the distance from the top of the pivot rail to the bottom of the blade. Make this
measurement at each end of the pivot rail. The two measurements should be the same
as the main bed rails.
4. Use the bolt shown to adjust the height of the pivot rail.
See Figure 5-18.
5. Use the set screws to adjust the angle of the pivot rail. Pivot the rail and check in 45°
positions as shown.
6. Adjust as needed until the pivot rail measures the same distance (±1/32) from the blade in
the 45°, 90°, and -45° positions.
CAUTION! Do not roll logs or large cants onto pivot bed
rails.
IMPORTANT! Logs and large cants will damage the pivot
bed rails or cause misalignment!
FIG. 5-18