Sawmill Assembly
Bed Section Assembly
Sawmill Assembly
doc072619
3-5
3
See Figure 3-7.
IMPORTANT!
Make sure the top surfaces of the outer side of the bed sections
are aligned. It may be necessary to adjust one bed section up or down until
the surfaces are aligned, then tighten the bolts.
If the rails do not meet flush at the joint, loosen the 8 rail bolts, adjust the rail as needed.
3.
Insert the splice bolts into the holes in the track rail and secure with two 3/8-16 x 1” hex head
bolts.(If rail bolts were loosened, retighten them at this time.)
See Figure 3-8.
NOTE:
The threaded holes at the end of the splice are provided to help
remove the splice if you wish to disassemble the sawmill. Remove the two
splice bolts from the middle holes and thread into the end holes. Evenly turn
the bolts clockwise to push the splice pins out of the track rail holes.
FIG. 3-7
FIG. 3-8
150070-1C
Align top bed tube surfaces
1/2-13 x 5" Hex
Head Bolt (4)
1/2-13 Nylon
Lock Nut (4)
150070B
Thread bolts in end
holes to remove
splice
3/8-16 x 1"
Hex Head Bolt (2)
Splice
