INSTALLER’S GUIDE
Page 14
Figure 11 Loose Coal Identification
Figure 10 Front Base Coal
Position
Figure 9 Rear Base Coal Position
Figure 8 Burner Tray Trim
6 F I T T I N G T H E C E R A M I C S
1.
Fit the burner tray trim over the front rim of the
burner tray. Push the trim fully down. See figure 8.
2.
Place the rear base coal in the firebox. It should
rest on the ledges at the sides and back of the firebox
and its rear face should touch the firebox rear wall.
See figure 9.
3.
Place the front base coal in the firebox with its
bottom front locating over the front rim of the
firebox. Pull the coal forward so that it locates
immediately behind the front rim of the firebox.
See figure 10.
4.
There are two types of loose coals.
Type “A” coals have a prominent lip. There are
three coals of this type.
Type “B” are squarer than type “A” and have two
grooves on their top surface.
The coals are shown in figure 11.
Identify these coals before attempting to fit them.
