INSTALLER’S GUIDE
Page 10
Figure 5 Burner fixing point
•
The burner assembly is retained by one
screw set in the front leg - See Figure 5.
Remove the screw and carefully remove the
burner assembly by lifting and sliding forward
from the firebox. The burner is produced from
a soft ceramic material and should be handled
carefully.
•
A foam seal is supplied which will need
to be attached to the rear face of the firebox
frame on all three sides. Ensure that all joints
are butted together to prevent air gaps.
3.4
The Gas Supply Pipe
8mm rigid tubing must be used to connect the gas supply to the appliance. An olive and
nut are provided for connection to the “T” connector on the appliance. The connector can
be rotated to allow connection from either side or the rear. The connector includes a
valve for isolating the gas supply.
3.5.1
If a
concealed connection
from inside the fireplace is required then,
before the
appliance is fitted into the fireplace
it will be necessary to extend the supply line so
that it will project through the sealed grommet at the back of the firebox and run to the
“T” connector.
