22
11.1
With its feather
edge at the top, place
the ceramic rear wall
into the channel at the
back of the firebox.
Push the wall flat
against the rear of the
fire box. (See figure
18).
11.2
Fit the tray
trim over the front
edge of the burner
tray. Make sure
that it is pushed
down fully.
Place the front
base coal in the
burner
compartment so
that it rests on the
ledges at the sides
and front. Pull the
coal forward so
that it is
immediately
behind the front
rim of the burner
compartment. (See
figure 19)
.
11.3
Place the rear
base coal in the
burner compartment
behind the front coal.
It should rest on the
ledge at the back of
the burner
compartment and its
rear face should touch
the rear ceramic wall
(See figure 20)
11.4
Install the 9 loose
coals as follows. The
smooth surfaces of the
coals should be at the
bottom and back.
11.4.1
Select the two
smallest coals and put
them aside until all the
other coals are installed.
Place four of the
medium size coals in
the four valleys of the
front coal. Place the left
side coal so that the
pilot flame will be
visible. (See figure
21).
11.4.2
Place the three
remaining medium
size coals behind and
approximately
midway between
each of the coals in
the front row (See
figure 22).
11.4.3
Place the two
remaining small
coals alongside the main
coals (See figure 23)
P A R T 1 1 :
C E R A M I C C O A L S & W A L L I N S T A L L A T I O N
Fig 23 Small side coals
Fig. 22 Middle row of coals
Fig. 20 Rear base coal
installation
Fig. 21 Front row of coals
Fig. 19 Tray trim & front base
coal installation
Fig. 18 Ceramic rear wall
installation
