OWNER’S GUIDE
Page 12
The position of the pebbles is
important. Do not alter the
position of the pebbles from
that shown in this section of the
owner’s guide.
5.
There are four pebbles
numbered ‘1’ on the underside.
Locate these onto the pebble base
at the ends of the outer
left and right hand
ceramic support rods
(See figure 8).
6.
There are two
pebbles numbered ‘2’ on
the underside. Locate
these on the pebble base
between the ends of the
inner left and right
ceramic support rods
(See figure 9).
Important note
: The gap
between the number ‘2’
pebbles affects the final
flame picture. If the
flames tend to the sides of
the fuel bed then
increase
the gap between the
number ‘2’ pebbles. If the
flames tend to the centre
of the fuel bed then
decrease the gap between
the number ‘2’ pebbles.
The amount of movement may be as little as 3 – 5mm.
7.
Pebble ‘3’ has a location peg on the underside. The peg has a chamfer on one side.
The chamfer must face the burner. Locate pebble ‘3’ onto the left hand side of the pebble
base. It should bridge the gap between the front and rear halves of the pebble base. Pebble
‘3’ should not touch the burner cover (Figure 10).
Figure 10 Pebble number ‘3’ Location
Figure 9 Pebble number ‘2’ Location
Figure 8 Pebble number ‘1’ Location
