OWNER’S GUIDE
Page 9
Figure 4 Front Base Coal Position
Figure 3 Rear Base Coal Position
Burner
•
The burner surface can be carefully cleaned to remove any loose particles after taking
off the ceramic fuel effect pieces. Make sure that no particles are pushed into the burner
slots.
Note:
Surface cracking of the burner is normal and no cause for concern.
REFITTING CERAMICS
Fitting Coals to models supplied with Coal Ceramic Fuel Effect.
(For Pebble models see section ‘Fitting pebbles to models supplied with Pebble Ceramic
Fuel Effect’)
1.
Place the rear base coal in the firebox. It
should rest on the ledges at the sides and back
of the firebox and its rear face should touch the
rear ceramic wall. See figure 3.
2
.
Place the front base coal in the firebox
with its bottom front locating over the front rim
of the firebox. Pull the coal forward so that it
locates immediately behind the front rim
of the firebox. See figure 4.
There are two types of loose coals. These
are identified with the letter “A” or “B”
on the underside of the coal.
There are three “A” coals and two “B”
coals.
