3
Remove the inner side panel from the unit.
Remove the Outer Panel
1
Use a Phillips screwdriver to remove the screws around the
outside of the outer panel.
2
Lift the outer panel from the unit.
OUTER PANEL INSTALLATION
Install the Inner Side Panel
1
Place the inner side panel flat against the frame, so that the
tabs align with the slots in the frame.
2
Rotate the inner side panel upward into position.
TIP: It may be necessary to close the inner panel to allow
enough clearance for the inner side panel to rotate.
3
Use a Phillips screwdriver to install the inner side panel
screws.
Install the Outer Panel
1
Place the outer panel onto the unit.
2
Use a Phillips screwdriver to install the screws around the
outside of the outer panel.
LED LIGHT REMOVAL (STAINLESS STEEL)
Remove the LED Light Assembly
1
Use a flat-blade screwdriver to pull the LED light assembly
away from the stainless steel panel.
2
Pull the LED light assembly's wire harness far enough
through the hole to access the connector.
3
Disconnect the wire harness from the LED light assembly.
4
Remove the LED light assembly from the unit.
5
Use a Phillips screwdriver to remove the diffuser sleeve
from the LED light.
LED LIGHT INSTALLATION (STAINLESS STEEL)
Install the LED Light Assembly (Stainless Steel)
1
Use a Phillips screwdriver to install the diffuser sleeve onto
the LED light.
2
Connect the LED light wire harness.
TIP: The other end of the wire harness may be inside the
stainless steel panel on the other side of the hole. Pull it through
far enough to access the connector.
3
Place the LED light assembly on the stainless steel panel.
4
Push the LED light assembly into the stainless steel panel.
Ceiling-Mounted Hood
REMOVE THE INNER SIDE PANEL (continued)
service.subzero.com
828149 REV. A
6